New Wall Construction - Dimplex DFP6848 Owner's Manual

Site Selection and Preparation
fireplace insert is provided
by three (3) rubber feet
(Figure 1).
fireplace insert directly on
carpet or similar surfaces
which may restrict air
circulation. If installing the
fireplace in a carpeted area,
place a one-piece, solid, flat
surface under the fireplace
insert. Ensure that all three
(3) of the insert's feet rest
securely on this surface.
Existing Fireplace
1. Seal all drafts and vents
with non-fibrous insulation
materials to prevent chimney
debris from falling into the
fireplace insert. Do not install
into an existing fireplace
that is prone to leaks or
dampness.
2. Cap the top of the chimney
flue to prevent rain from
entering.
3. Plan your electrical power
supply (refer to noTE 1).
4. The power cord can run along
the front of the hearth to an
outlet near the fireplace.
!
NOTE 1: A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
8
Do not install the
but not essential in all cases.
A dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNINg: To prevent
personal injury you should
hire a professional to cap the
chimney flue or cut a hole in
the existing fireplace for wiring.
If you return your existing
fireplace to its original use
(example wood burning), it
should be inspected by the
local building department prior
to use to reduce the risk of fire
and personal injury.

New Wall Construction

1. select a suitable location that
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
!
NOTE: The fireplace insert
must be installed on a hard
surface.
2. Place the fireplace in the
desired location to see how it
will look in the room.
www.dimplex.com