Dimplex DFP6848 Owner's Manual page 15

Maintenance
CAUTION: Even though the
glass is safety glass it may
break if bumped, struck or
dropped. Care must be taken
when handling the glass.
Lower Light Bulb Requirements
Quantity of four (4) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating.
CAUTION: Do not exceed 60
Watts per lamp.
To replace the bottom light
bulbs:
1. Lift up the front edge of the
log until it clears the front
tabs. Pull out until the rear
tab clears the back ledge,
then lift out (Figure 7).
2. Examine the bulbs to
determine which bulbs require
replacement.
3. Hold the socket while
unscrewing the bulb.
4. Hold the socket while
screwing in the new bulb.
5. replace the log by pushing
it down and in until it rests
against the partially reflective
glass.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating. Please refer to
the label adjacent to the upper
lamps for the correct wattage for
your model.
CAUTION: Do not exceed 25
Watts per lamp.
To replace the top light bulbs:
1. Locate the two (2) upper
bulbs inside the firebox at the
top.
2. Examine the bulbs to
determine which bulbs require
replacement.
3. Hold the socket while
unscrewing the bulb.
4. Hold the socket while
screwing in the new bulb.
To reassemble lamp area
1. replace the glass and hold it
in place at the top (Figure 6B).
Figure 7
Back
Ledge
Rear
side section
Tab
Log
Emberbed
Front
Edge
15