Maintenance - Dimplex DFP6848 Owner's Manual

Maintenance

WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
Light Bulb Replacement
WARNINg: Allow at least five
(5) minutes for light bulbs to
cool off before touching bulbs
to avoid accidental burning of
skin.
Light bulbs need to be replaced
when you notice a dark section
of the flame or when the clarity
and detail of the log exterior
disappears. There are two (2)
bulbs at the top of the opening
which illuminate the log set
exterior, and four (4) bulbs under
the log set which generate the
flames and embers.
Helpful Hints: It is a good
idea to replace all light bulbs at
one time if they are close to the
Figure 6
Removing
Glass
14
A
end of their rated life. Group
replacement will reduce the
number of times you need to
open the unit to replace light
bulbs.
Tool Requirements: Slot
screwdriver
!
NOTE: Before replacing
lamps unnecessarily, ensure
that they are not simply loose
or that the brightness control
is not adjusted to low setting
(see item C in operation
section).
To open the light bulb area:
1. Remove the trim by pulling
straight forward.
2. Hold the glass in place while
removing the retaining clip
from the upper center of the
firebox (Figure 6A).
3. Lift glass out and store in a
safe place.
B
replacing
Glass
C
Retaining
Clip
Holding
Glass
www.dimplex.com