Fireplace Installation - Dimplex DFP6848 Owner's Manual

Site Selection and Preparation
5. Assemble the mantel
surround kit (refer to the
mantel assembly instructions)
or construct the custom
surround with an opening of
26 ½ inches wide X 23 inches
high (67.3 cm wide X 58.4 cm
high) allowing a depth of 12

Fireplace Installation

This section provides easy step
by step instructions for installation
of your fireplace.
1. Install Trim Kit to front of
fireplace by positioning trim
then pushing straight forward
against the fireplace.
2. Make sure the unit is
switched off (refer to
operating instruction section).
3. Plug the fireplace into a 15
Amp/120 Volt outlet. If the
cord does not reach you may
use a extension cord rated for
a minimum of 1875 Watts.
4. Push the fireplace into place
so that the trim is against the
finished mantel surround or
wall surface (Figure 3)
5. Level, if required with wood
shims (not included).
10
inches (30.5 cm) (Figure 2B).
WARNINg: Do not attempt
to wire your own new outlets
or circuits. To reduce the risk
of fire, electric shock or injury
to persons, always use a
licensed electrician.
WARNINg: Ensure the
power cord is not installed so
that it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Figure 3
Insert
Wall or
Mantel
Trim
Push
www.dimplex.com