Remote Control - Dimplex DFP6848 Owner's Manual

Operation
clockwise all the way to turn
on the heater. When the room
reached the desired temperature,
turn the thermostat knob counter
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at this
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a
normal condition caused by
initial heating of internal heater
parts and will not occur again.
Resetting the Temperature
Cutoff Switch
This unit is equipped with a
thermostat which controls the
temperature of the room. It does
this by turning the heater on
and off. The heater is protected
with a safety device to prevent
overheating. should the heater
overheat, an automatic cut out
will turn the heater off and it will
not come back on without being
reset. It can be reset by switching
the on/off switch to off and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need
12
to continuously reset the
heater, unplug the unit and
call Dimplex north America
Limited at 1-888-346-7539
for technical support. Please
have your model and serial
number ready when calling.

Remote Control

The fireplace is supplied with a
radio frequency remote control.
This remote control has a
range of approximately 50 feet
(15.25m). It does not have to
be pointed at the fireplace and
can pass through most obstacles
(including walls). It is supplied
with one of 243 independent
frequencies to prevent
interference with other units. The
frequency designation is indicated
on the back of the remote control.
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
1. Ensure that power is supplied
through the main service
panel.
2. open upper grille to access
manual controls. (Figure 4)
3. Turn on/off switch to on
(Figure 4A).
www.dimplex.com