Dimplex DFP6848 Owner's Manual page 13

Operation
4. Press and hold the 3-Position
switch marked " I " for five
seconds (red indicator light
will flash). (Figure 4E)
5. Press the on button located
on the remote control. (Figure
5)
This will synchronize the remote
control and receiver.
Remote Control Usage
The remote control operates
the fireplace levels sequentially,
flames only to flames and low
heat, to flames and high heat The
level is increased every time the
on button on the remote control
is pressed. The fireplace can be
turned off at any point by pressing
the OFF button on the remote
control.
Level 1 : The flame effect
is turned on and the first red
indicator light is activated.
Level 2 : The flame effect
remains on, the heater is
activated to the low heat setting,
and the first and second red
indicator lights are activated.
Level 3 : The flame effect
remains on, the heater is set to
the high heat setting, and all three
red indicator lights are activated.
!
NOTE: When fireplace is
turned on by remote control
the fireplace will start with
flames only. The level can be
increased every time the on
button on the remote control is
pressed.
Battery Replacement
To replace the battery:
1. slide battery cover open on
the remote control (Figure 5).
2. Install one (1) 12-Volt (A23)
battery in the battery holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or retailer for recycling
advice in your area.
Figure 5
On
Button
off Button
Battery
Battery
Cover
13