Quick Reference Guide; Site Selection And Preparation - Dimplex DF3215 Owner's Manual

Quick Reference guide

① Before using the fireplace
verify:
• Are the circuit breakers for
the unit on?
• Are the light bulbs loose? (to
check, follow the instructions
for replacing the light bulbs
under the maintenance
section of this manual)

Site Selection and Preparation

!
NOTE 1: A 15amp, 120 volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNINg: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your own
② If you have any technical
questions or concerns regarding
the operation of your electric
fireplace, or require service
contact customer service.
③ The heater may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts.
new outlets or circuits. To reduce
the risk of fire, electric shock or
injury to persons, always use a
licensed electrician.
This section provides instructions
for selecting a location and
preparing the site to install the
fireplace into your Dimplex mantel
surround.
1. select a suitable location that
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
2. For ease of electrical hook
up you may wish to locate
the fireplace near an existing
outlet (refer to noTE 1).
3. store the fireplace in a safe
7