Maintenance - Dimplex DF3215 Owner's Manual

Maintenance

WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes for
light bulbs to cool before touching
bulbs to avoid accidental burning
of skin.
Light bulbs need to be replaced
when you notice a dark section
of the flame or when the clarity
and detail of the log ember bed
exterior disappears. There are
four (4) bulbs under the log set,
which generate the flames and
embers, and two (2) bulbs above
the log that illuminate the log
exterior.
Lower Light Bulb
Requirements
Quantity of four (4) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating. Example: GE
60BC or Philips 60 CTC. Do not
exceed 60 Watts per bulb.
Helpful Hints: It is a good
idea to replace all light bulbs at
one time if they are close to the
end of their rated life. Group
16
replacement will reduce the
number of times you need to
open the unit to replace light
bulbs. Care must be taken when
removing the Log Set as the Log
set contains LED's and wires.
To access the lower light bulb
area (Figure 7):
1. open the Bi-fold doors.
2. Pull the front edge of the
plastic Ember Bed or plastic
grate up and forward until the
rear tab releases from the
ledge located at the bottom of
the Partially reflective Glass.
!
IMPORTANT: Only handle the
Log set by the Ember Bed.
!
NOTE: Log set fits tightly
into firebox, some force may be
necessary to remove.
3. set Log set in front of firebox.
4. Disconnect the Log set LED
Figure 7
Light Bulbs
Ember
Bed
LED Wire
Harness
www.dimplex.com