Main On/Off Switch Replacement - Dimplex DF3215 Service Manual

Figure 11
Rubber Extrusions
Log Set
Support
Bracket
Steel Curtain, Log Set and Bottom Panel removed for clarity
fireplace. Slide the bracket directly out the bottom of the
fireplace and set aside.
10. Slide Mirror down and out the bottom of the fireplace.
11. Align sides of replacement Mirror with grooves of rubber
extrusions and with brick effect facing out towards the
front of the fireplace, slide Mirror up into the fireplace.
The Mirror should slide into a holding track just beneath
the filter.
12. Slide Log Set Support Bracket back into place, the sides
of the bracket lining up with the grooves of the rubber
extrusions (Figure 11).
13. Reinstall Log Set while support bracket is loose within
fireplace. The back edge of the Log Set should fit under
the bottom edge of the Mirror, and the front edge of the
Log Set should fit in behind the top, inside edge of the
Log Set Support Bracket (see Figure 6, page 8).
14. Install Log Set Support Bracket using the six (6) screws
from step 7 (or, if rivets were originally in place, use the
screws supplied with RP kit for Mirror).
15. Reconnect the LED Wire Harness for the Log Set.
16. Reassemble the bottom panel of the fireplace following
steps 1-5 in reverse order.
Main On/Off Switch Replacement
If the fireplace was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Main On/Off Switch Replacement Procedure:
1. Remove the firebox from the mantel.
2. Remove the eight (8) Philips screws that fasten the top
Mirror
These edges of bracket
slide into grooves of
extrusions
cover to the rest of the firebox. There are: three (3)
screws on each side along the top edge; and two (2)
screws on the back along the top edge (Figure 12).
Figure 12
Top Section of Fireplace
3. Flip the top panel over and rest it on the top of the
fireplace.
CAUTION: Use caution when flipping top panel over as
there are components attached to the top panel which
are wired to the internal cavity of the fireplace.
4. Open the bi-fold doors and steel curtain.
5. Locate the Main On/Off Switch mounted on the top of the
fireplace on the right side (Figure 13) and disconnect the
two (2) wiring clips noting their original locations.
6. Depress the two (2) retainer clips on the sides of the
Figure 13
Black wire to
Power Cord
Orange wire to
Circuit Board
Main On/Off
Switch
switch and push the switch through the sheet metal and
into the fireplace display cavity. Remove from the front of
the fireplace
10
Retainer Clip