Top Panel (Analog Input/Output Section) - Fostex VF80EX Owner's Manual

Names and functions (VF80EX)
2
1
INPUT A
BAL
12
UNBAL
CH ON/OFF
11
TRACK STATUS
1
+6
0
-10
-20
-30
-40
-
1. [INPUT A/UNBAL] (Unbalanced) connector
• Connects to the unbalanced output of an external sound
source.
• Reference input level: -50 dBV to +2 dBV
• Connector type: phone jack
• When this connector is plugged, the input from the
[INPUT A/BAL] connector is interrupted.
2. [INPUT A/BAL] (Balanced) connector
• Connects to the balanced output of an external sound
source.
• Reference input level: -50 dBV to +2 dBV (approx. -48
dBu to +4 dBu)
• Connector type: XLR-3-31 type (pin #2 hot)
• A phantom power (+48 V) can be supplied for using a
condenser microphone by setting the [PHANTOM]
switch on the rear panel to ON.
• When the [INPUT A/UNBAL] connector is plugged, the
input from this connector is interrupted.
3. [INPUT A/TRIM] knob
• Controls the gain according to the signal from [INPUT
A].
• You can adjust the gain to accept input signals between
-50 dBV (MIC) and +2 dBV (LINE).
4. [INPUT B/UNBAL] (Unbalanced) connector
• Connects to the unbalanced output of an external sound
source.
• Reference input level: -50 dBV to +2 dBV
• Connector type: phone jack
• When this connector is plugged, the input from the
[INPUT B/BAL] connector is interrupted.

Top panel (Analog input/output section)

4
6 8
3 5
7
INPUT B PHONES
L
BAL
TRACK
EDIT
GUITAR GUITAR
LINE MIC LINE MIC MIN MAX
TRIM UNBAL TRIM
BOUNCE
CH ON/OFF
PEAK PEAK
REC EFF
RED REC GREEN PLAY
TRACK STATUS / TRACK SEL
2 3 4 5 6
+6 +6 +6 +6 +6
0
0 0 0 0
-10 -10 -10 -10 -10
-20 -20 -20 -20
-20
-30 -30 -30 -30 -30
-40
-40 -40 -40 -40
- - - -
-
9
10
ST OUT
FOOT SW
R
MIX PARAMETER
SCENE SCENE SEQ.
PGM FADER MAP
PAN EQ EFFECT
ON/OFF
2TRK MODE
MASTERING TRAINING
F1
OFF MUTE
STATUS
/SEL
7/8 2TRK MASTER
CURSOR
+6 +6
0 0
TIMEBASE
SETUP SEL
-10 -10 F1
F2
AUTO
PUNCH LOOP
-20
-20
-30 -30
EDIT EDIT
-40 -40
RECORD STOP
-
-
5. [INPUT B/BAL] (Balanced) connector
• Connects to the balanced output of an external sound
source.
• Reference input level: -50 dBV to +2 dBV (approx. -48
dBu to +4 dBu)
• Connector type: XLR-3-31 type (pin #2 hot)
• A phantom power (+48 V) can be supplied for using a
condenser microphone by setting the [PHANTOM]
switch on the rear panel to ON.
• When the [INPUT B/UNBAL] connector is plugged, the
input from this connector is interrupted.
6. [INPUT B/TRIM] knob
• Controls the gain according to the signal from [INPUT B].
• You can adjust the gain to accept input signals between
-50 dBV (MIC) and +2 dBV (LINE).
7. [PHONES] (Headphones) knob
• Adjusts the level of headphones for monitoring.
8. [PHONES] (Headphones) connector
• Connects headphones for monitoring.
• Connector type: TRS phone jack
9. [ST OUT L. R] (Stereo out) connector
• Outputs the stereo (L and R) buss signal.
• Connects to a master recorder, etc.
• Reference output level: -10 dBV
• Connector type: phone jack
14
ACCESS
PHANTOM
F2 F3
JOG SHUTTLE
EXIT
/NO
EJECT
ENTER
/YES
UNDO
/REDO
F3
SHIFT
LOCATE
WAVE FORM
VARI
PITCH SCRUB
EDIT CD PLAY MARK DELETE
PLAY REWIND F FWD
LOCATE ABS 0
LOCATE REC END