Setting The Record Protect Function - Fostex VF80EX Owner's Manual

On the Select Menu screen of the SETUP mode, se-
1
lect "Slave Type" and press the [ENTER/YES] key.
The currently selected slave type starts flashing (by
default, "Vari" is selected).
Use the [JOG] dial to select the desired slave type
2
and press the [ENTER/YES] key.
The selected slave type is set.
Setting the Recording protect function ["Rec Protect"]
Using the "Rec Protect" menu item, you can select the recording protection "On" or "Off". This is similar to the
"recording protection tabs" of a cassette tape. When it is set to "On", you cannot make recording, paste or
erase data, etc.
• Default: Off
• Available options: On, Off
* The setting is applicable program by program.
* You can save the setting as a part of the song data.
* The setting remains effective even after you power off and then
on.
On the Select Menu screen of the SETUP mode, se-
1
lect "Rec Protect" and press the [ENTER/YES] key.
The current setting starts flashing (by default, "Off"
is selected).
Use the [JOG] dial to select "0n" or "Off", and press
2
the [ENTER/YES] key.
The selection is set.
Off (default) You can make recording, paste or
erase data, etc.
On You cannot make recording, paste or
erase data, etc.
Press the [EXIT/NO] key (or the [STOP] key) repeat-
3
edly until the VF80EX exits the SETUP mode.
Free
Vari
(default)
flashing
SPDIF
Press the [EXIT/NO] key (or the [STOP] key) repeat-
3
edly until the VF80EX exits the SETUP mode.
<Note>
If you try to make recording, paste or erase data while
[Rec Protect] is set to "On", [Protected] is shown on the
display for a second and the operation is canceled.
To make the operation possible, set [Rec Protect] to "Off".
flashing
141
SETUP mode (VF80EX)
After the chase-lock is achieved, the VF80EX
switches to run freely according to the internal
clock or the clock received from the digital input.
It does not chase the master even if the VF80EX
timecode shifts off the master timecode.
After the chase-lock is achieved, the VF80EX
always check the timecode difference and runs
in the vari-speed mode to chase the master.
However, when the digital input is selected, it
runs the same as "Free" described above.
After the chase-lock is achieved, the VF80EX
runs freely according to the S/PDIF clock when
an S/PDIF digital signal is fed from the master.
However, when the digital input is selected, it
runs according to the digital input clock.