Setting Pump Parameters - Viessmann VITOSOLIC 200 Installation And Service Instructions Manual

Setting parameters
Note
All parameters are reset into their deliv-
ered condition when the setting for "Sys-
tem" is changed.

Setting pump parameters

Check which type of pumps are connec-
ted and set parameter "Control"
accordingly (see page 69).
Activating additional functions
■ For each system, additional functions
can be activated (see the table for the
respective system from page 95).
Functions for which the same relay
output is used can only be used alter-
nately.
Example system 1 (see page 95):
The "Parallel relay" function can only
be activated if no additional function
for DHW heating was activated.
■ For functions that can be selected
independently of the relay assign-
ment, see the following table.
Function
Cylinder priority control
(only in conjunction with several consumers, systems 3 to 5)
Collector emergency stop
Interval function
Collector cooling function
Return cooling function
Frost protection
Target temperature
Cylinder (2 to 4)
Overheat
Collector minimum limit
Cyclical heating
(cont.)
Commissioning
Page
117
118
127
128
129
129
130
134
134
135
135
83