Viessmann VITOSOLIC 200 Operating Instructions Manual
Control unit for solar thermal systems
Hide thumbs
Also See for VITOSOLIC 200:
- Installation and service instructions manual (172 pages) ,
- Operating instructions manual (16 pages) ,
- Operating instructions for the system user (16 pages)
Related Manuals for Viessmann VITOSOLIC 200
Summary of Contents for Viessmann VITOSOLIC 200
- Page 1 VIESMANN Operating instructions for the system user Control unit for solar thermal systems VITOSOLIC 200 Please keep safe. 5608 437 GB 4/2014...
- Page 2 Safety instructions For your safety Please follow these safety instructions closely to In case of fire prevent accidents and material losses. Danger Safety instructions explained Fire presents a risk of burns and explosion. ■ Switch the system OFF. Danger ■ Use a tested fire extinguisher, class ABC.
-
Page 3: Introductory Information
Introductory information Commissioning The commissioning and adjusting of the control unit to local conditions and to building characteristics, plus the instruction of the user in operating the system, must be carried out by your heating contractor. - Page 4 Operation Operation Controls 30.04.2009 10:59 Tcol 47.7 °C Tcylb 35.4 °C Fig. 1 Standard display Cursor keys The standard display is shown automatically To scroll through the menu. after approx. 4 min. Cursor keys OK key; to confirm your selection or save the To adjust values.
-
Page 5: Scanning Options
Scanning options Calling up actual values Press the following keys: for the following actual values, subject to sys- tem equipment level. for the "Main menu". until the "Main menu" appears. 2. OK the first 3 actual values will be displayed. "Actual values:"... -
Page 6: Scanning Statement Values
Scanning options Calling up messages Press the following keys: 3. OK to confirm. for the "Main menu". to display further messages (see table below). for "Messages". "Messages:" Explanation No fault There is no fault at the solar control unit. "Loading cyl" The display shows which consumer is being heated. - Page 7 Scanning options Calling up the heat amount Press the following keys: for "HM 1" or "HM 2". for the "Main menu". 5. OK to confirm. for "HM". for the following values, subject to system equipment level. 3. OK to confirm. until the "Main menu"...
-
Page 8: The Solar Thermal System Does Not Start
What to do if... The solar thermal system does not start Cause Remedy The ON/OFF switch is switched off. Switch the ON/OFF switch ON. The solar control unit MCB has responded (mains volt- Inform your local heating contractor. age is present, display is not illuminated). Collector limit temperature or set cylinder temperature Wait until the relevant temperature has fallen below its has been reached. - Page 9 What to do if... Calling up faults If any faults have occurred in your solar thermal sys- tem, the display illumination flashes and "Fault" appears on the standard display. 30.04.2009 10:59 Tcol 47.7 °C Tcylb 35.4 °C Fault Fig. 5 Press the following keys: for the "Main menu".
-
Page 10: Dhw Cylinder (If Installed)
If there is damage to the connecting cables or lines of the appliance or externally installed accessories, these must be replaced with special cables or lines. Only use Viessmann cables / lines as replacement. For this, notify your qualified contractor. -
Page 11: Menu Overview
Menu overview Menu overview Subject to the specific system equipment level and range of functions (set by your heating contractor), the displays may vary from the examples illustrated here. Main menu Actual values Reports Solar Manual mode Messages: Operator code back No fault !Interruption... - Page 12 Your contact Contact your local contractor if you have any questions regarding the maintenance and repair of your system. You may, for example, find local contractors on the internet under www.viessmann.com. Viessmann Werke GmbH & Co. KG Viessmann Limited D-35107 Allendorf...