Toshiba Strata CIX40 R5.2 Software - R1 ~ R3 Hardware Installation And Maintenance Manual page 48

CIX40 Installation
Detailed PCB Installation
Step 4: Install the GCTU2 (Processor)
The GCTU2 is the main processor for the CIX40. It is shipped in a separate box, not in the CIX40
cabinet. The GCTU2A is considered a unit, separate from the cabinet for repair, return and
warranty purposes.
 To install the GCTU2 into the CIX40
1. If you have not already removed the PCB stopper, remove the two screws and the PCB
stopper (see
2. Set the P601 battery jumper to ON (see
the GMAS sub-motherboard (see
of the PCB stopper (see
3. Secure the PCB stopper with the original two screws.
4. Insert the SecureDigital card (gold contacts to left and front, notched corner faces forward and
down) into the SecureDigital slot on the GCTU2 (see
Figure 1-22 GCTU2 PCB
1-38
Figure 1-21).
Figure 1-10
Figure 1-21).
Battery Jumper
Figure 1-22) and insert the GCTU2 in the upper slot of
and Figure 1-11). Place it next to the guide rail
Figure 1-22).
SecureDigital Card Slot
BSIS Connector
Strata CIX40 R3 Installation & Maintenance
Heart Beat LED
Secure Digital LED
DC Power LED
LAN Port
Paging
MOH
Relay Contact
05/10