Table of Contents
Advertisement
to the battery's positive terminal (+). Then con-
nect the black cable to the battery's negative ter-
minal (-).
If the cables are disconnected/connect-
ed in the wrong order, there is a risk of
a short-circuit and damage to the bat-
tery.
If the cables are interchanged, the gen-
erator and the battery will be damaged.
The engine must never be driven with
the battery disconnected. There is a risk
of serious damage to the generator and
the electrical system.
5.8.4 Cleaning
If the battery terminals are coated with oxide, they
should be cleaned. Clean the battery terminals with
a wire brush and lubricate them with terminal
grease.
5.9 Air filter, engine
5.9.1 Air filter
(Ranger, President, Power)
The pre-filter (foam filter) must be cleaned/re-
placed after 25 hours of operation.
The air filter (paper filter) must be cleaned/re-
placed after 100 hours of operation.
NOTE! The filters should be cleaned/replaced
more often if the machine operates on dusty
ground.
Remove/install the air filters as follows.
1. Clean carefully around the air filter cover.
2. Dismantle the air filter cover (23:A) by remov-
ing the two clamps.
3. Dismantle the filter assembly (23:B). The pre-
filter is placed over the air filter. Make sure that
no dirt gets into the carburettor. Clean the air fil-
ter housing.
4. Clean the paper filter by tapping it gently
against a flat surface. If the filter is very dirty,
replace it.
5. Clean the pre-filter. If the filter is very dirty, re-
place it.
6. Assemble in the reverse order.
Compressed air or petroleum-based solvents such
as kerosene may not be used for cleaning the paper
filter insert. This will damage the filter.
5.9.2 Air filter (Excellent)
The pre-filter (foam filter) must be cleaned after 25
hours of operation.
The air filter (paper filter) must be replaced after
100 hours of operation.
ENGLISH
NOTE! The filters should be cleaned/replaced
more often if the machine operates on dusty
ground.
Remove/install the air filters as follows.
1. Dismantle the right rear wheel.
2. Clean carefully around the air filter cover.
3. Dismantle the air filter cover (21:A) by undoing
its screw (21:B).
4. Dismantle the filters. The pre-filter (21:C) is
placed over the air filter (21:D). Make sure that
no dirt gets into the carburettor. Clean the air fil-
ter housing.
5. Wash the pre-filter (21:C) in liquid detergent
and water. Squeeze dry. Pour a little oil on the
filter and squeeze in the oil.
6. Assemble in the reverse order. Check that the
rubber seal (21:E) is undamaged. Replace the
seal if necessary.
5.10 Spark plug
The spark plug(s) must be replaced every 200
hours of operation (=at every other basic service).
Before disconnecting the spark plug, clean around
its mounting.
Spark plug: Champion RC12YC or equivalent.
Electrode distance: 0.75 mm.
5.11 Air intake
See 10, 11, 12:W. The engine is air-cooled. A
blocked cooling system can damage the engine.
Clean the engine's air intake after 50 hours of op-
eration. More meticulous cleaning of the cooling
system is carried out during each basic service.
EN
63
Hide quick links:
Advertisement
Table of Contents
