Advanced Nat/Route Mode Settings; Using The Setup Wizard; Starting The Setup Wizard; Reconnecting To The Web-Based Manager - Fortinet FortiGate 50A Installation And Configuration Manual

NAT/Route mode installation

Advanced NAT/Route mode settings

Using the setup wizard

Starting the setup wizard

Reconnecting to the web-based manager

FortiGate-50A Installation and Configuration Guide
Use Table 13 to gather the information that you need to customize advanced
FortiGate NAT/Route mode settings.
Table 13: Advanced FortiGate NAT/Route mode settings
DHCP server
From the web-based manager, you can use the setup wizard to create the initial
configuration of your FortiGate unit. To connect to the web-based manager, see
"Connecting to the web-based manager" on page
1 Select Easy Setup Wizard (the middle button in the upper-right corner of the
web-based manager).
2 Use the information that you gathered in
Select the Next button to step through the wizard pages.
3 Confirm your configuration settings and then select Finish and Close.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For each server located on your
internal network the FortiGate unit adds an Ext->Int policy.
If you used the setup wizard to change the IP address of the internal interface, you
must reconnect to the web-based manager using a new IP address. Browse to https://
followed by the new IP address of the internal interface. Otherwise, you can reconnect
to the web-based manager by browsing to https://192.168.1.99.
You have now completed the initial configuration of your FortiGate unit, and you can
proceed to "Connecting the FortiGate unit to your networks" on page
Starting IP:
Ending IP:
Netmask:
Default Route:
DNS IP:
The FortiGate unit contains a DHCP server that you can configure to
automatically set the addresses of the computers on your internal network.
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
19.
Table 12 on page 34 to fill in the wizard fields.
Using the setup wizard
37.
35