Table of Contents
Advertisement
Completing the configuration
Configuring the Transparent mode management IP address
Configure the Transparent mode default gateway
Completing the configuration
Setting the date and time
Enabling antivirus protection
64
1
Log into the CLI if you are not already logged in.
2
Set the management IP address and netmask to the IP address and netmask that you
recorded in
Table 14 on page
set system management ip <IP address> <netmask>
Example
set system management ip 10.10.10.2 255.255.255.0
3
Confirm that the address is correct. Enter:
get system management
The CLI lists the management IP address and netmask.
1
Log into the CLI if you are not already logged in.
2
Set the default route to the default gateway that you recorded in
Enter:
set system route number <number> gw1 <IP address>
Example
set system route number 0 gw1 204.23.1.2
You have now completed the initial configuration of the FortiGate unit.
Use the information in this section to complete the initial configuration of the FortiGate
unit.
For effective scheduling and logging, the FortiGate system date and time should be
accurate. You can either manually set the system date and time or you can configure
the FortiGate unit to automatically keep its time correct by synchronizing with a
Network Time Protocol (NTP) server.
To set the FortiGate system date and time, see
page
157.
To enable antivirus protection to protect users on your internal network from
downloading a virus from the Internet:
1
Go to Firewall > Policy > port1->port2.
2
Select Edit
to edit this policy.
3
Select Anti-Virus & Web filter to enable antivirus protection for this policy.
4
Select the Scan Content Profile.
5
Select OK to save your changes.
61. Enter:
"Setting system date and time" on
Transparent mode installation
Table 14 on page
Fortinet Inc.
61.
- Quick Links:
- Deleting Addresses
Hide quick links:
Advertisement
Table of Contents
