Nat/Route Mode With Multiple External Network Connections - Fortinet FortiGate 400 Installation & Configuration Manual

Planning your FortiGate configuration

NAT/Route mode with multiple external network connections

40
Figure 4: Example NAT/Route mode network configuration
In NAT/Route mode, you can configure the FortiGate unit with multiple redundant
connections to the external network (usually the Internet). For example, you could
create the following configuration:
• Interface 1 is the interface to the internal network.
• Interface 2 is the default interface to the external network (usually the Internet).
• Interface 3 is the interface to the DMZ network.
• Interface 4/HA is the redundant interface to the external network.
You must configure routing to support redundant internet connections. Routing can be
used to automatically re-direct connections from an interface if its connection to the
external network fails.
Otherwise, security policy configuration is similar to a NAT/Route mode configuration
with a single Internet connection. You would create NAT mode policies to control traffic
flowing between the internal, private network and the external, public network (usually
the Internet).
If you have multiple internal networks, such as a DMZ network in addition to the
internal, private network, you could create route mode policies for traffic flowing
between them.
Figure 5: Example NAT/Route multiple internet connection configuration
Getting started
Fortinet Inc.