Configuring Interface 4/Ha; Setting The Date And Time; Enabling Antivirus Protection; Registering Your Fortigate Unit - Fortinet FortiGate 400 Installation & Configuration Manual

NAT/Route mode installation

Configuring interface 4/HA

Setting the date and time

Enabling antivirus protection

Registering your FortiGate unit

FortiGate-400 Installation and Configuration Guide
Use the following procedure to configure interface 4/HA to connect to a network:
1 Log into the web-based manager.
2 Go to System > Network > Interface.
3 Choose port4/ha and select Modify
4 Make sure that Work as HA is not selected.
5 Change the IP address and Netmask as required.
6 Select Apply.
For effective scheduling and logging, the FortiGate system date and time should be
accurate. You can either manually set the system date and time or you can configure
the FortiGate unit to automatically keep its time correct by synchronizing with a
Network Time Protocol (NTP) server.
To set the FortiGate system date and time, see
page 157.
To enable antivirus protection to protect users on your internal network from
downloading a virus from the Internet:
1 Go to Firewall > Policy > port1->port2.
2 Select Edit to edit this policy.
3 Select Anti-Virus & Web filter to enable antivirus protection for this policy.
4 Select the Scan Content Profile.
5 Select OK to save your changes.
After purchasing and installing a new FortiGate unit, you can register the unit by going
to System > Update > Support, or using a web browser to connect to
http://support.fortinet.com and selecting Product Registration.
Registration consists of entering your contact information and the serial numbers of
the FortiGate units you or your organization have purchased. Registration is quick and
easy. You can register multiple FortiGate units in a single session without re-entering
your contact information. For more information about registration, see
FortiGate units" on page
.
125.
Completing the configuration
"Setting system date and time" on
"Registering
51