Table of Contents
Advertisement
Configuring Transparent mode
Configuring Transparent mode
Using the web-based manager
26
Configuring Transparent mode involves switching to Transparent mode,
configuring the management IP address, default routes, and simple firewall
policies. You can use the web-based manager or the CLI to configure the
FortiGate unit in Transparent mode.
After connecting to the web-based manager, you can use the following
procedures to complete the basic configuration of the FortiGate unit. Ensure you
read the section
"Connecting to the web-based manager" on page 18
beginning.
Switching to Transparent mode
The FortiGate unit comes preset to NAT mode. You need to switch to Transparent
mode.
To switch to Transparent mode
1
Go to System > Status.
2
Select Change beside the Operation Mode.
3
Select Transparent.
4
Enter the Management IP/Netmask address and the Default Gateway address.
The default gateway IP address is required to tell the FortiGate unit where to send
network traffic to other networks.
5
Select Apply.
Configure a DNS server
A DNS server is a service that converts symbolic node names to IP addresses. A
domain name server (DNS server) implements the protocol. In simple terms, it
acts as a phone book for the Internet. A DNS server matches domain names with
the computer IP address. This enables you to use readable locations, such as
fortinet.com when browsing the Internet.
DNS server IP addresses are typically provided by your internet service provider.
To configure DNS server settings
1
Go to System > Network > Options.
2
Enter the IP address of the primary DNS server.
3
Enter the IP address of the secondary DNS server.
Select Apply.
Adding firewall policies
Firewall policies enable traffic to flow through the FortiGate interfaces. Firewall
policies define the FortiGate unit process the packets in a communication session.
You can configure the firewall policies to allow only specific traffic, users and
specific times when traffic is allowed.
FortiGate-310B FortiOS 3.0 MR6 Install Guide
01-30006-0472-20080815
Configuring
before
Advertisement
Table of Contents
