Table of Contents
Advertisement
Transparent mode installation
Example static route to an external destination
FortiGate-400 Installation and Configuration Guide
Web-based manager example configuration steps
To configure basic Transparent mode settings and a default route using the
web-based manager:
1
Go to System > Status.
•
Select Change to Transparent Mode.
•
Select Transparent in the Operation Mode list.
•
Select OK.
The FortiGate unit changes to Transparent mode.
2
Go to System > Network > Management.
•
Change the Management IP and Netmask:
IP: 192.168.1.1
Mask: 255.255.255.0
•
Select Apply.
3
Go to System > Network > Routing.
•
Select New to add the default route to the external network.
Destination IP: 0.0.0.0
Mask: 0.0.0.0
Gateway: 192.168.1.2
•
Select OK.
CLI configuration steps
To configure the Fortinet basic settings and a default route using the CLI:
1
Change the system to operate in Transparent Mode.
set system opmode transparent
2
Add the Management IP address and Netmask.
set system management ip 192.168.1.1 255.255.255.0
3
Add the default route to the external network.
set system route number 1 gw1 192.168.1.2
Figure 11
shows a FortiGate unit that requires routes to the FDN located on the
external network. The Fortigate unit does not require routes to the DNS servers or
management computer because they are located on the internal network.
To connect to the FDN, you would typically enter a single default route to the external
network. However, to provide an extra degree of security, you could enter static routes
to a specific FortiResponse server in addition to a default route to the external
network. If the static route becomes unavailable (perhaps because the IP address of
the FortiResponse server changes) the FortiGate unit will still be able to receive
antivirus and NIDS updates from the FDN using the default route.
Transparent mode configuration examples
69
- Quick Links:
- Deleting Addresses
Hide quick links:
Advertisement
Table of Contents
