Network configuration
Deleting zones
Configuring interfaces
Viewing the interface list
Bringing up an interface
FortiGate-400 Installation and Configuration Guide
You must remove all interfaces and VLAN subinterfaces from a zone before you can
delete the zone. You can only delete zones that have the Delete icon
in the zone list.
1
Go to System > Network > Zone.
2
Select Delete
3
Select OK to delete the zone.
Use the following procedures to configure the FortiGate interfaces:
•
Viewing the interface list
•
Bringing up an interface
•
Changing an interface static IP address
•
Adding a secondary IP address to an interface
•
Adding a ping server to an interface
•
Controlling management access to an interface
•
Configuring traffic logging for connections to an interface
•
Changing the MTU size to improve network performance
•
Configuring port4/ha
•
Configuring the management interface (Transparent mode)
Use the following procedure to view the interface list.
1
Go to System > Interface.
The interface list is displayed. The interface list shows the following status information
for all of the FortiGate interfaces and VLAN subinterfaces:
•
The IP address of the interface
•
The netmask of the interface
•
The zone that the interface has been added to
•
The administrative access configuration for the interface
•
The link status for the interface (link status does not apply to VLAN subinterfaces)
If the link status is a green arrow, the interface is up and can accept network traffic.
If the link status is a red arrow, the interface is down and cannot accept traffic. To
bring an interface up, see the procedure
If the link status of an interface on the interface shows that it is down, you can use the
following procedure to bring the interface up.
1
Go to System > Interface.
The interface list is displayed.
2
Select Bring Up for the interface that you want to bring up.
to remove a zone from the list.
Configuring interfaces
"Bringing up an
interface".
beside them
135