Shelf Manager Fan And Power Control; Fortigate-5050 Shelf Alarm Panel - Fortinet FortiGate 5050-R Chassis Manual

FortiGate-5050 chassis

Shelf Manager fan and power control

FortiGate-5050 shelf alarm panel

FortiGate-5050-R Chassis Guide
01-30000-87717-20090108
http://docs.fortinet.com/ • Feedback
Figure 3: FortiGate-5050 shelf manager front panel
Reset
ETH 0 and 1 network
activity LEDs
Button
5000SM
10/100
link/Act
10/100
link/Act
Retention ETH0
Screw 100base-T
Ethernet
Table 2: FortiGate-5050 shelf manager LEDs
LED State
ETH 0 10/100 Yellow
ETH 1
link/Act Green
Off
STATUS Green
Red
HOT SWAP Off
Blue
Long blink
Short blink
The FortiGate-5050 shelf managers monitor the internal temperature of the
FortiGate-5050 chassis and adjust the operating speed of the FortiGate-5050 chassis
cooling fan as required. If the temperature in the chassis becomes too high, the shelf
managers can also power down FortiGate-5000 modules installed in the chassis to help
reduce the temperature.
When the chassis is first powered on all cooling fans run at full speed. Once the shelf
manager is up and running, the shelf manager reduces cooling fan speeds to maintain an
optimum temperature in the chassis. If shelf managers are not installed or not operating
correctly the FortiGate-5050 chassis cooling fans always operate at full speed.
The FortiGate-5050 shelf alarm panel (SAP), located at the bottom of the FortiGate-5050
front panel, provides LED indicators of FortiGate-5050 alarms, a telco alarm connector, an
alarm LED reset button, and console access to the FortiGate-5050 shelf managers. The
LED alarm indicators include critical, major, and minor alarms as well as three user
defined alarms.
The alarm LED reset button (RESET) on the shelf alarm panel activates the Alarm Cutoff
(ACO) state. When ACO is activated, the active alarm LEDs blink and all of the alarm
relays are deactivated.
Hot Swap
LED
Status Handle
LEDs
Description
The Ethernet interface is connected at 100 Mbps.
Blinking LED indicates network traffic.
No link.
This shelf manager is operating normally as the active shelf
manager. Usually the primary shelf manager operates as the
active shelf manager.
This shelf manager is operating normally as the backup shelf
manager. Usually the secondary shelf manager operates as the
standby shelf manager.
The shelf manager is not ready to be removed.
The shelf manager is ready to be removed.
The shelf manager is starting up after being inserted into the
chassis.
The shelf manager is shutting down in preparation for being
removed from the chassis.
FortiGate-5050 shelf alarm panel
9