Installation - Alpine VPE-S431 Operating Instructions Manual

Installation

Installing the Monitor
Installation Location
Before deciding on the mounting location, check that opening and
closing the display will not hamper gear shifting in that position.
• Install at an angle of within 30 degrees from the horizontal.
• The monitor's angle is set to 90 degrees at the factory. Depending
on the car, the monitor may hit the dashboard when opened. The
monitor's angle can be adjusted and stored in memory so that the
monitor will not hit the dashboard when opening. For adjusting the
monitor, refer to "Adjusting the monitor Angle" on page 26.
Even when the vehicle's battery power is removed, the adjusted
monitor angle remains stored in memory.
1
Bracket
Mounting Sleeve
(Included)
Hex Bolt
(Included)
Rubber Cap
(Included)
Dashboard
Screws (M4 × 3)
(Included)
Slide the mounting sleeve into the dashboard. Install the
supplied bracket on the monitor.
• Make sure to use the supplied screw (M4 × 3) to install the
monitor.
If you use another screw to install the monitor, it may cause a
malfunction.
2
Hex Nut (M5)
Metal Mounting
Strap
Ground
Lead
Chassis
Mounting Bracket
(Included)
IVA-D300R/
IVA-D300RB
Screw
Bolt Stud
IVA-D300R/
IVA-D300RB
Front Frame
(Included)
Wider edge should face down.
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the IVA-D300R/IVA-D300RB
and put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the monitor
unit with the metal mounting strap (not supplied). Secure
the ground lead of the unit to a clean metal spot using a
screw (}) already attached to the vehicle's chassis.
• For the screw marked }}, use an appropriate screw for the
chosen mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from
the left rear of the IVA-D300R/IVA-D300RB. Connect all
other leads of the IVA-D300R/IVA-D300RB according to
details described in the Connections section.
3
Lock Pin
Slide the IVA-D300R/IVA-D300RB into the dashboard.
When the unit is in place, make sure the locking pins are
fully seated in the down position. This can be done by
pressing firmly in on the unit while pushing the locking pin
down with a small screwdriver. This ensures that the unit is
properly locked and will not accidentally come out from
the dashboard. Install the supplied Front Frame.
Removal
1. Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see Step 3). As each
pin is unlocked, gently pull out on the unit to make sure
it does not re-lock before unlocking the second pin.
2. Pull the unit out, keeping it unlocked as you do so.
< JAPANESE CAR >
To install using the vehicle's genuine bracket.
Ground Lead IVA-D300R/
IVA-D300RB
• Make sure to use the supplied screw (M4 × 6) to install the
monitor.
If you use another screw to install the monitor, it may cause a
malfunction.
Screws (M4 × 6)
(Included)
Mounting Bracket
67
-EN