Table of Contents
Advertisement
Storing the Adjusted Contents
Following operation is performed after Step 3 above.
4 Touch [MEMORY].
5 Within 5 seconds, touch any one of preset buttons
[P.SET 1] through [P.SET 6] on the BASS ENGINE
screen.
The adjusted contents will be stored on the preset
number you touch.
• The stored contents on the P.SET number remain undeleted despite
a reset operation or disconnection of the battery power cord.
• Adjusted/set contents of each setting item in Bass Engine can be
stored in the preset buttons (1 through 6).
Recalling the Stored Adjusting Contents
Following operation is performed after Step 3 above.
4 Touch any one of [P.SET 1] to [P.SET 6] on the BASS
ENGINE screen.
The stored adjusting contents will be recalled.
Subwoofer On and Off
Setting item: SUBWOOFER
Setting contents: OFF / 0° / 180°
OFF: Subwoofer output is off.
0°:
Subwoofer output is on, and the phase is 0°.
180°: Subwoofer output is on, and the phase is 180°.
• Adjusted/set contents of each setting item in Bass Engine can be
stored in the preset buttons (1 through 6).
40
-EN
VISUAL EQ™
Visual EQ Setting Operation
The following steps 1 to 6 are common operations to each
"Setting item" of VISUAL EQ setting. Refer to each section
for details
1
Touch [SYS.] on the main source screen.
The SYSTEM selection screen is displayed.
2
Touch [i-Personalize].
The i-Personalize setup screen appears.
3
Touch [
] of VISUAL EQ.
VISUAL EQ screen appears.
4
Select a desired setting item by touching [ ] or
[ ].
Setting items:
VISUAL EQ* ↔ BRIGHT ↔ COLOR* ↔ TINT* ↔ CONTRAST
↔ SHARP* ↔ USER MEMORY*
* The setting is available in the visual source mode. (except
navigation screen)
5
Change the setting on the selected item by
touching its [;] or [:].
6
Touch [RETURN] to return to the previous screen.
Touch [MAIN CONT.] to return to the main source screen
that was displayed before the setup operation was
started.
Selecting the VISUAL EQ Mode (Maker's setting)
You can select a mode suitable for the subject image.
Setting item: VISUAL EQ
Setting contents: OFF (FLAT) / NIGHT M. / SOFT / SHARP /
CONTRAST / P-1 / P-2
OFF (FLAT): Initial Setting
NIGHT M.:
Suitable for movies in which dark scenes
frequently appear.
SOFT:
Suitable for CGs and animated films.
SHARP:
Suitable for old movies where images are not
clearly shown.
CONTRAST: Suitable for recent movies.
P-1:
Recalls the VISUAL EQ mode being stored on
preset No.P-1 from "Storing VISUAL EQ" (page
41).
P-2:
Recalls the VISUAL EQ mode being saved on
preset No.P-2 from "Storing VISUAL EQ" (page
41).
• To return to the initial setting, after selecting any one of the setting
contents (NIGHT M. to CONTRAST) and adjusting a desired
brightness, picture tint, etc., set this function to OFF.
• If your desired brightness, picture tint, etc., are adjusted after
selecting any one of the setting contents (NIGHT M. to
CONTRAST), "CUSTOM" is displayed.
Adjusting Brightness
Setting item: BRIGHT
Setting content: -15 ~ +15
You can adjust the brightness between MIN (–15) and MAX (+15).
When it reaches the minimum or maximum point, the display shows
"MIN" or "MAX" respectively.
Hide quick links:
Advertisement
Table of Contents
