Door Release Settings [Set Door Release] - Aiphone JM-4MED Installation Manual

■ Settings for the usage of the option outputs
[OPTION OUTPUT]
1
From th e [INSTALL] menu window, touch
OPTION OUTPUT .
The [OPTION OUTPUT] window is displayed.
2
Change the settings by touching the items
in the table below.
1
2
3
Item
1 EVENT Set to "ENABLE" so that it is highlighted
ACTIVATION
to make this station transfer alarm to the
connected external device.
Also select the action that triggers this station
to transfer the alarm at
* When set to "ENABLE",
grayed out and disabled.
Set to "DISABLE" to make this station output
signals when OPTION is touched in the
HOME window.
2 DURATION Touch this repeatedly to select the duration
time of outputting signals.
Setting range:
MOMENTARY, 1, 3, 5, 10, 15, 20, 25, 30,
60 sec. (seconds)
3 TRIGGER (When [EVENT ACTIVATION] is set to
EVENT "ENABLE" only):
Select the action that triggers this station to
transfer the alarm.
DOOR CALL
ROOM CALL
ALARM ON
VIDEO OUT
Procedure:
Touch the preferred action so that it is
highlighted. Up to four actions can be
selected.
3
When fi nished adjusting the settings, touch
18
1 - 3 as
Description
3
.
OPTION is
Receiving a call from a
...
door station
Calling a single or all
..
sub master stations, or
receiving a call from a sub
master station
Triggering an alarm for
.....
UTILITY or SECURITY
setting
Outputting video signals
....
while receiving a call from,
communicating with, or
monitoring a door station
ENTER .
Door release settings
[SET DOOR RELEASE]
Adjust the settings for controlling the door release devices
connected to the "L1" and "L2" terminals.
1
From th e [INSTALL] menu window, touch
SET DOOR RELEASE .
The [SET DOOR RELEASE] window is displayed.
2
Touch LOCK1 to change the settings for "L1".
Set for "L1" and "L2" respectively.
*
3
Change the settings for "L1" by touching the items
- 3 as in the table below.
1
2
3
Item
1 OUTPUT Touch this, and then select the output
METHOD
method "N/O" or "N/C" so it is highlighted.
2 REFERENCE Touch this to change for active (SHOW) or
DOOR (for
not (HIDE) to release the door lock for "L1"
DOOR1 - 4)
when communicating with the door station 1
- 4.
* Adjust the setting for "DOOR1" to
"DOOR4" respectively.
e.g.)
If "DOOR1" is set to "SHOW", when
receiving a call from or monitoring the door
station 1,
Touching it activates the door release device
connected to "L1".
If it is set to "HIDE",
and disabled.
3 DOOR Touch this, and then select the desired door
RELEASE
release time so that it is highlighted.
DURATION
Setting range:
MOMENTARY, 1, 3, 5, 10, 15, 20, 25, 30,
60 sec.
* If this is set to "MOMENTARY", the door
release is activated while
touched and held.
4 Adjust "L2" using the same directions as "L1".
1
Description
1 is displayed on the screen.
1 is grayed out
1 is