Enabling/Disabling Door Release [General] - [Door Release]; Security Settings [General] - [Alarm Setting] - [Security Setting]; Setting The Exit Delay Setting And Return Delay Setting; Setting The Alarm Pin - Aiphone JP-4MED Operation Manual

Enabling/Disabling door release
[GENERAL] - [DOOR RELEASE]
You can make it possible (ENABLE) or not (DISABLE) to
release door locks from this station.
Set for Door 1 to Door 4 individually.
If "DOOR1" is set to "ENABLE", when receiving a call from
a door station or while monitoring an entrance,
2 are displayed on the screen. Touching
activates the door release device for Door 1.
If it is set to "DISABLE",
and disabled.
1
From HOME window, touch
GENERAL DOOR RELEASE .
→
2 Enter the 4-digit PIN by using the touchscreen, then
touch ENTER .
"DOOR1" to "DOOR4" are displayed.
If a wrong PIN has been entered, an error message
*
is displayed. Enter correct PIN. (See page 10 for PIN
settings).
3
To change the setting for "DOOR1", select "ENABLE"
or "DISABLE".
4
Repeat for other door stations.
5
When the setting has fi nished, touch
Security settings [GENERAL] -
[ALARM SETTING] - [SECURITY SETTING]
These settings are available when the inputs 1, 2, and/or 3
*
are set to "SECURITY" by the [INSTALL] menu, and a sensor
is connected to each input.
Make the following settings for using the security function.
14
1 and
1
1 and 2 are grayed out
SETTINGS →
ENTER .
■ Setting the EXIT DELAY SETTING and
RETURN DELAY SETTING
Select an alarm delay to allow for enough time to vacate or
enter the premises before alarm is triggered.
Setting range: 0, 30, 60, 120, 300, 600 seconds
1
From HOME window, touch
ALARM SETTING
GENERAL →
SECURITY SETTING .
2
Touch EXIT DELAY SETTING or
RETURN DELAY SETTING .
3 Touch the preferred time so that it is highlighted.
Use " " or " " to scroll between times.
*
4
When the setting has fi nished, touch

■ Setting the ALARM PIN

Set an ALARM PIN if you need it to deactivate ARMED AWAY.
This setting is also applied to all sub master stations in this
*
system.
The default is "DISABLE" (no ALARM PIN is set or used).
1
From HOME window, touch
ALARM SETTING
GENERAL
→
SECURITY SETTING .
2
Touch ALARM PIN .
"1" to "9", and "0" are displayed.
3 Enter a 4-digit number as the ALARM PIN by
touching numbers one by one.
The entered ALARM PIN is displayed.
4
When the setting has fi nished, touch
ALARM PIN is set to "ENABLE".
To DISABLE the ALARM PIN
Proceed to step 3 above. Do not enter the ALARM PIN, but
instead touch DISABLE .
SETTINGS →
→
ENTER .
→
SETTINGS
→
ENABLE .