Door Release; Other - Aiphone GT-DMB-N Operation Manual

ENTRANCE STATION

Door release

2-2
■ Door release by using the access code
*
The access code is preset by the system installer or
administrator.
1
In standby mode, enter [#] and then the access
code (4 to 6 digits) using [0] to [9] on the 10-key.
[Modular type]
1 2 3
B E
4 5 6
H K N
7 8 9
U
0
(e.g.)
When the access code is "4567", enter "#", "4", "5", "6", "7".
The door is released.
•
The door release indicator lights up.
•
Audio guidance will be heard depending
on the settings.
*
If there is no relevant number, "DENIED" is displayed.
*
Door release is enabled even while the IN USE LED is lit.

Other

2-3
*
Calling from an entrance station is disabled while the IN USE LED is lit.
Wait until the IN USE LED turns off.
For a multi building system with lift control, if you unlock from a
NOTE:
room and terminate call at the same time, the entrance station may
not unlock properly.
■ Door release by an NFC-compliant IC card,
A card incorporated with an NFC tag can be used to release a door.
To use, the ID of the NFC tag must be registered as a door release
code.
1
[All-in-one-type]
NOTE:
- 16 -
etc.
Pass an NFC-compliant IC card over the NFC
reader.
[Modular type]
NFC reader
*
Put the card within 10 mm of the NFC reader. Otherwise, the
code may not be read correctly.
The door is released.
•
The door release indicator lights up.
•
Audio guidance will be heard depending
on the settings.
*
Door release is enabled even while the IN USE LED is lit.
Do not overlap IC cards when passing them over the
NFC reader. The code may not be read correctly.
[All-in-one-type]