Monitoring; Scan-Monitoring - Aiphone IS-SOFT Operation Manual

Monitoring

You can monitor a sub station or multiple sub stations in your
site sequentially (scan-monitoring) with a PC master station.
When monitoring a video door station, you can view the
*
image at the station and hear the sound. When monitoring an
audio door station or room sub station, you can only hear the
sound at the station.
■ Monitoring
1 Search for and select the sub station in your site you
want to monitor (so that it is highlighted) in one of the
search methods. (→P. 21-24)
NOTE:
You cannot monitor a (PC) master station and remote site.
2 (when " [ ] MONI" is displayed).
Click
You can hear the sound and if the station has a camera,
you can also view the image.
*
appears in the area for a status display icon.
3 Click to fi nish monitoring.
NOTES:
If the selected station is being used (calling, communicating, being
•
monitored, etc.), you cannot monitor the station.
If you click while monitoring, the communication mode starts
•
with the station after a tone.
During video monitoring, you can switch Zoom/Wide, make Pan
•
& Tilt control and adjust images on the monitor. (
To shift to scan-monitoring
k duri
Clic ng monitoring.
If the station being monitored is a preset one for scan-
*
monitoring, the scan-monitoring starts from the subsequent
station in the scan-monitoring order.
If the station being monitored is not a preset one for scan-
*
monitoring, the scan-monitoring starts from the fi rst station in
the scan-monitoring order.
26

■ Scan-monitoring

You can monitor the preset stations in your site (up to 20 door
stations and/or room sub stations) sequentially, each for the set
duration.
The stations should be preset in the System setting on the IP
*
host unit.
1
Click
The stations set for scan-monitoring are monitored
sequentially, each for the set duration.
*
2 Click
*
To monitor only the desired station continuously:
Click
scan-monitoring.
*
NOTES:
Clicking
•
If the PC master station receives a call during scan-monitoring, the
•
scan-monitoring ends automatically.
• If one of the preset stations is being used (calling, communicating,
being monitored, etc.) during the scan-monitoring, it will be
skipped.
During the scan-monitoring, the Zoom/Wide, Pan & Tilt, door
•
release, image adjusting function, etc. are disabled. (The camera is
fi xed in the Wide mode.)
→
P. 15-16)
in the standby mode.
If the scan-monitoring target station is only one, the scan-
monitoring ends after a lapse of approx. 11 minutes.
to stop scan-monitoring .
appears in the area for a status display icon during
scan-monitoring.
when the target station is being monitored during
Click again to restart the scan-monitoring.
is invalid during scan-monitoring.