Obsolete commands are deprecated, older forms of commands that still
work but have been replaced by newer commands.
Obsolete Command
:MEASure:CLOCk:METHod
(see
page
:MEASure:DDPWS (see
page
1005)
Discontinued
Discontinued commands are commands that were used by previous
Commands
oscilloscopes, but are not supported by the Infiniium 90000 Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
Discontinued Command
:DISK:STORe
Agilent Infiniium 90000 Series Oscilloscopes
Programmer's Reference
36
Obsolete and Discontinued Commands
Current Command Equivalent
•
:MEASure:CLOCk:METHod
1002)
(see
•
:MEASure:CLOCk:METHod:J
TF (see
•
:MEASure:CLOCk:METHod:O
JTF (see
:MEASure:RJDJ:ALL? (see
page
Current Command Equivalent
":DISK:SAVE:SETup"
page 288
":DISK:SAVE:WAVeform"
page 289
s1
page
496)
page
502)
page
504)
618)
on
on
Behavior Differences
The command options for
specifying clock recovery PLL
options have been moved to
the new commands
:MEASure:CLOCk:METHod:JT
F and
:MEASure:CLOCk:METHod:OJ
TF.
The :MEASure:RJDJ:ALL?
query returns all of the RJDJ
jitter measurements.
Comments
For saving setups and
waveforms to disk.
1001