Measure:clock:method - Agilent Technologies Infiniium 90000 Series Programmer's Manual

36
Obsolete and Discontinued Commands

:MEASure:CLOCk:METHod

(deprecated)
Command
Some of these command options have been deprecated — options for specifying clock
N O T E
recovery PLL options have been moved to the new commands
":MEASure:CLOCk:METHod:JTF"
page 504. See also
:MEASure:CLOCk commands are available when clock recovery is used by licensed
N O T E
software (like the E2688A High Speed Serial software or the N5400A/N5401A EZJIT Plus
jitter analysis software).
:MEASure:CLOCk:METHod {FOPLL,<data_rate>,<loop_bandwidth>}
The :MEASure:CLOCk:METHod command sets the clock recovery method
to:
• FOPLL (first order phase- locked loop).
• SOPLL (second order phase- locked loop).
• EQFOPLL (equalized first order phase- locked loop).
• EQSOPLL (equalized second order phase- locked loop).
• PCIE (PCI Express).
• FC (Fibre Channel).
• EXPFOPLL (Explicit First Order PLL).
• EXPSOPLL (Explicit Second Order PLL).
• EXPlicit (Explicit Clock).
• FIXed (Constant Frequency).
• FLEXR (FlexRay Receiver).
• FLEXT (FlexRay Transmitter).
1002
":MEASure:CLOCk:METHod"
| {EQFOPLL,<data_rate>,<loop_bandwidth>}
| {SOPLL,<data_rate>,<loop_bandwidth>, <damping_factor>}
| {EQSOPLL,<data_rate>,<loop_bandwidth>, <damping_factor>}
| {PCIE,{DEEMphasis | TRANsition | BOTH}}
| {FC,{FC1063 | FC2125 | FC425}}
| {EXPFOPLL,<source>,{RISing | FALLing | BOTH},
<multiplier>,<clock_freq>,<loop_bandwidth>}
| {EXPSOPLL,<source>,{RISing | FALLing | BOTH},
<multiplier>,<clock_freq>,<loop_bandwidth>,<damping_fact>}
| {EXPlicit,<source>,{RISing | FALLing | BOTH}[,<multiplier>]}
| {FIXed,{AUTO | {SEMI[,<data_rate>]} | <data_rate>}}
| {FLEXR,<baud_rate>}
| {FLEXT,<baud_rate>}
Agilent Infiniium 90000 Series Oscilloscopes Programmer's Reference
on page 502 and ":MEASure:CLOCk:METHod:OJTF"
on page 496.
on