Agilent Technologies 4294A Operating Manual page 416

Key Definitions
Softkeys displayed by pressing the [System] key
Table B-80 IBASIC command name (Command Name) menu
Key operation: [System] - IBASIC - more 1/3 - more 2/3 - COMMAND ENTRY
Softkey
CLEAR NAME Deletes all entered characters.
done Finishes the entry of characters and executes the entered command.
cancel Cancels the entry of characters and returns to Table B-77, "HP Instrument
BASIC (IBASIC) menu (3/3)," on page 406.
Table B-81 Mass storage (Store Device) menu
Key operation: [System] - PROGRAM MENU - STORE DEV [ ]
[Save] - STORE DEV [ ]
[Save] - STATE/ CREATE DIRECTORY/ CHANGE DIRECTORY/ COPY
FILE/ FILE UTILITIES - STORE DEV [ ]
Softkey
FLOPPY
Selects the flexible disk drive as the mass storage
|
MEMORY
Selects the volatile memory disk as the mass storage
|
FLASH MEMORY
Selects the nonvolatile memory disk (flash memory) as the mass storage
return Returns to Table B-111, "File selection (Select File) menu," on page 424.
1. The selection of the mass storage device is set independently in each of the following menus: this menu, Table B-79, "IBASIC
mass storage (Mass Storage) menu," on page 407, and Table B-115, "Copy destination device (Dest Device) menu," on page
425. However, there is only a single set of mass storage devices for all menu selections.
Table B-82 Limit test (Limit Test) menu
Key operation: [System] - LIMIT TEST
Softkey
LIMIT TEST on OFF Toggles on and off the limit line test function. If this is set to on, according to the
limit line table, the limit lines are displayed on the screen and the limit test is
executed.
BEEP FAIL on OFF Toggles on and off the beep that sounds each time the result of a limit line test is
failure (FAIL).
EDIT LIMIT LINE ä
Displays Table B-83, "Limit line edit (Edit Limit) menu," on page 409.
Regardless of the setting in Table B-21, "Display allocation (Disp Alloc) menu,"
on page 369, the upper half of the screen displays the measured graph, and the
lower half displays the limit line table.
LIMIT LINE Displays Table B-88, "Limit line offset (Limit Offset) menu," on page 412.
OFFSETS ä
return Returns to Table B-74, "System (System) menu," on page 404.
408
Function
Function
1
.
1
.
Function
GPIB command
(N/A)
(N/A)
(N/A)
GPIB command
STOD DISK
STOD MEMO
STOD FLASH
1
.
(N/A)
GPIB command
LIMITEST {ON|OFF}
DEEPFAIL {ON|OFF}
EDITLIML
(N/A)
(N/A)
Appendix B