Agilent Technologies 4294A Operation Manual
Precision impedance analyzer data transfer program
Hide thumbs
Also See for 4294A:
- Programming manual (518 pages) ,
- Operating manual (469 pages) ,
- Configuration manual (8 pages)
Related Manuals for Agilent Technologies 4294A
Summary of Contents for Agilent Technologies 4294A
- Page 1 Agilent 4294A Precision Impedance Analyzer 4294A Data Transfer Program Operation Manual Rev.03.10 Oct. 2011...
-
Page 2: Sample Program
SAMPLE PROGRAMS solely and exclusively for their own purpose and shall not license, lease, market, or distribute the SAMPLE PROGRAMS or modification of any part thereof. Agilent Technologies shall not be liable for the quality, performance, or behavior of the SAMPLE PROGRAMS. Agilent Technologies especially disclaims any responsibility for the operation of the SAMPLE PROGRAMS to be uninterrupted or error-free. - Page 3 2. Connect the 4294A and the PC using the 82357A/B USB/GPIB interface. Then the connection will be automatically configured. After the connection is properly configured, the 4294A appears on “Instrument I/O on this PC” pane of Agilent Connection Expert as shown in the figure below.
- Page 4 1. Run Agilent Connection Expert by double-clicking the icon in the task tray Double click 2. Connect the 4294A and the PC using a LAN cable. The type of LAN cable depends on the connection method. - Straight LAN cable for:...
- Page 5 - IP address Set the 4294A’s IP address just off by 1 (or so) from the PC’s IP address. For example, if the IP address of the PC is 100.100.10.10 then the 4294A’s IP address can be set to 100.100.10.11.
- Page 6 5. “Add LAN Instruments” dialog box appears then click “Add Address” button. 6. Enter the information as shown in the figure below.
- Page 7 If the setting are not correct, “Could not connect” message appears. In this case, check whether each step was followed correctly. 8. After step 7, the 4294A appears under “LAN(TCIPI0)” in the “Instrument I/O on this PC” pane. Select “TCPIP…” (the 4294A’s VISA address) and click “Change Properties…”...
- Page 8 10. When the icon “ ” is shown, the connection configuration between the 4294A and the PC is completed.
- Page 9 3. How to use the program 1. Set the measurement conditions, then perform the compensation. The 4294A can sweep frequency, oscillator level, or DC bias. 2. Perform the single trigger measurement with the DUT by pressing Trigger hardkey > SINGLE softkey.
- Page 10 4. Alignment with 4294A IBASIC program After making measurements using the 4294A IBASIC program such as the dielectric constant measurement sample program, the measurement data and display image also can be transferred to a PC using this VBA marco. To show the IBASIC key labels on the display after running the VBA marco, press System hardkey >...