Specify Partial Search Range; When Sweep Type Is Other Than List Sweep - Agilent Technologies 4294A Operating Manual
Precision impedance analyzer
Hide thumbs
Also See for 4294A:
- Programming manual (518 pages) ,
- Operation manual (10 pages) ,
- Configuration manual (8 pages)
Table of Contents
Advertisement
Specify partial search range
Under the presetting conditions, the maximum value search (
minimum value search (
search (
-
[Search]
PEAK
-
EQUIV CKT
CALCULATE PARAMETERS
The range to be searched can be specified by following these steps:
When sweep type is other than list sweep:
Step 1. Activate the trace in which you want to specify a partial search range.
Active Trace
Trace A
Trace B
Step 2. Press the
key to display the Search menu.
[Search]
Step 3. Press the
SEARCH RANGE MENU
Step 4. Press the
key to display the lower limit of the current partial search range in the
MINIMUM
set parameter value field in the upper left area of the screen.
Step 5. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the lower limit of the partial search range.
•
Enter the desired value with the numeric keys (
of the unit keys (
•
Turn the rotary knob (
•
Press the step keys ([][¯]) to set the desired value.
Step 6. Press the
MAXIMUM
set parameter value field in the upper left area of the screen.
Step 7. Use the keys or rotary knob of the ENTRY block in one of the following ways to specify
the upper limit of the partial search range.
•
Enter the desired value with the numeric keys (
of the unit keys (
•
Turn the rotary knob (
•
Press the step keys ([][¯]) to set the desired value.
Step 8. Press the
PART SRCH on OFF
label changes to
PART SRCH ON off
lines are displayed as boundary lines on each side of the specified search range in the
graph. (When the measurement parameter is COMPLEX Z-Y, the boundary lines are not
shown.)
Chapter 8
-
), target value search (
[Search]
MIN
) and equivalent circuit analysis (
) are executed over the entire sweep range.
Key operation
[A]
[B]
key to display the Search Range menu.
,
,
, or
).
[G/n]
[M/m]
[k/m]
[´1]
) until the desired value is set.
m m m m
key to display the upper limit of the current partial search range in the
,
,
, or
).
[G/n]
[M/m]
[k/m]
[´1]
) until the desired value is set.
m m m m
key to turn on the partial search range. Then the softkey
. If the partial search range is turned on, two vertical
Analysis and Processing of Result
Specify partial search range
-
), the
[Search]
MAX
-
[Search]
TARGET
-
-
[Display]
more 1/2
to
,
and
) and then press one
[0]
[9]
[-]
[.]
to
,
and
) and then press one
[0]
[9]
[-]
[.]
), peak
267
Advertisement
Table of Contents
