Driving Additional Coaxial Switches; Figure 2-4 Connections For Coaxial Switches - Agilent Technologies 11713A Operating And Service Manual

Driving Additional Coaxial Switches

Make switch connections to S0 outputs, S9 outputs, or to rear panel
ATTEN X output or ATTEN Y output.
Figure 2-4 shows the rear panel connections to S0 outputs and the
GPIB command necessary to change the position of Agilent 8762 or
8765 series coaxial switches. (For GPIB command usage, refer to
"Data Message Input Format")
Connections to Agilent 8762 or 8765 series coaxial switches can also
be made to the ATTEN X output or ATTEN Y output (refer to Figure
2-6 for connections/pin numbers). Control can be extended to four,
eight, or 10 switches if S0 and S9 outputs are also used.

Figure 2-4 Connections for Coaxial Switches

GPIB command "B0" connects port C and port 1 and turns the front
panel LED for pushbutton 0 OFF.
GPIB command "A0" connects port C and port 2 and turns the front
panel LED for pushbutton 0 ON.
Installing the Agilent Technologies 11713A Attenuator/Switch Driver
11713A Operating and Service Manual 2-9