Table of Contents
Advertisement
M
ANUALLY CONFIGURING THE
If there is no DHCP protocol to automatically assign IP addresses
to devices on your network, you might want to set the IP
Address, Subnet Mask and Default Gateway Address for your
printer manually.
1.
In the "Network Card Setup" pane, click to select the
printer.
2.
Click the Setting Printer icon. The Setting Printer dialog
appears.
3.
Select "Manual". In the Details section, you can now edit
the IP Address, Subnet Mask and Default Gateway
Address.
4.
Click OK. The "Admin Password Required" dialog appears.
5.
Enter the password. The default password is the last 6
digits of the MAC Address (upper case).
6.
Click OK. Allow a few seconds for the changes to save and
the printer to automatically restart before the "Setup
Completed" message box appears.
NOTE:
If your printer stops at any time, you can restart it by selecting
Printer -> Restart Printer in the "Network Card Setup pane".
C
A
HANGING THE
DMIN
To change the Admin Password for your printer:
1.
Select Settings -> Change Password.
2.
Enter the new password as requested.
3.
Click OK. Allow a few seconds as the settings are saved
and the printer automatically restarts.
E
/D
NABLE
ISABLE THE
To enable/disable access to the Printer Web Page from the
Network Card Setup utility:
1.
Select Settings -> Setting Printer.
2.
Select the "Printer Web Page" tab and select "Printer Web
Page - Disable" or "Printer Web Page - Disable".
IP
ADDRESS
P
ASSWORD
P
W
P
RINTER
EB
AGE
Windows> 19
Advertisement
Table of Contents
