Gemini GEM-P9600 Installation Instructions Manual page 21

WI742E 2/04
Configuring the GEM-RP2ASe2/GEM-K2AS and GEM-RP3DGTL/GEM-K3DGTL Keypads
Up to 7 GEM-RP2ASe2/GEM-K2AS and/or GEM-RP3DGTL/GEM-K3DGTL keypads may be connected to the panel
(Keypads 1–7). Each must be configured for a keypad address. In addition, the keypad may be configured to disable (a)
touchpad backlight; (b) LCD backlight; and (c) entry sounder. Keypads are configured by the proper selection of jump-
ers. Refer to the label on the circuit board insulation paper for jumper locations and a summary of settings. For the
GEM-RP4RFC/RP4C and GEM-K4RF/GEM-K4 keypads, see their respective installation instructions (listed on page 8).
GEM-RP2ASe2 KEYPAD
Jumper 1
1 2 3 P
1 2 3 P
GEM-RP3DGTL KEYPAD
Jumper 1
ADDRESS
NUMBER
1 1
2
2
1
3
3
2
P P
3
P
TOUCHPAD BACK LIGHT
Cut Jumper A to disable touch pad backlighting to conserve 11mA standby current.
LCD BACKLIGHT
Cut Jumper B to disable LCD backlighting.
DISABLE SOUNDER
Cut Jumper C to disable the sounder. (Do not disable in UL applications.)
L
NAPCO Security Systems
KEYPAD ADDRESS JUMPER
NUMBER
1 2
1 OFF OR OFF
ON
2 OFF ON
3 ON ON
4 OFF OFF
5 ON OFF
6 OFF ON
7 ON ON
KEYPAD NUMBER
1 2 3 4
OFF OR OFF ON OFF
ON
OFF ON ON OFF
OFF OFF OFF ON
MAY BE USED TO HOLD SPARE JUMPER
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
3 PARK
OFF MAY BE USED TO
HOLD SPARE
JUMPER
OFF
OFF
ON
ON
ON
ON
5 6 7
ON OFF ON
OFF ON ON
ON ON ON
X
GEM-P9600 Installation Instructions
Page 21
KEYPAD ADDRESS
If more than one keypad is in-
stalled:
!
Each must be assigned
unique address (that is, no two key-
pads may be numbered alike).
!
Keypads must be addressed
consecutively (that is, missing num-
bers are not permitted).
!
Only Keypad No. 1 may be used
for programming. (However, for
ease of programming, it is recom-
mended that a GEM-RP1CAe2/
GEM-K1CA be selected as Keypad
#1.)
Assign the keypad address number
by selecting Jumpers J1–3 in accor-
dance with the table at left.
*Note: (1) Keypads are factory
supplied with no jumpers installed
and as such are automatically con-
figured as Keypad No. 1. (2) Only
one keypad in the system may be
configured as Keypad No. 1, other-
wise none will function.
!
a