Remote Bus; Earth Ground; Auxiliary Power - Gemini GEM-P9600 Installation Instructions Manual

WI742E 2/04

REMOTE BUS

GEM-RP3DGTL
GEM-RP2CAe2
(1 LINE LCD KEYPAD)
(Only PGM Option 2 available)
Connect the available devices as shown above to the remote bus terminals (9, 10, 11 & 12). Observe the correct color
wire connections. When connecting a keypads, first configure them accordingly (refer to the Keypad Configuration
Mode at the back of this manual). Keypads should be located near every exit/entry door. Up to 15 keypads may be
connected if the longest cable run from the panel, to the farthest keypad (daisy chained or home-run) is less than 1000
feet. The maximum distance for seven keypads is 300 feet using 22 AWG. wire. NOTE: When running keypad wire,
avoid wiring parallel to other types of wiring that can cause electrical interference.

EARTH GROUND

NOTE: Do not use a gas pipe, plastic
pipe or AC ground connections.

AUXILIARY POWER

Connect the auxiliary devices (motion detectors, glass breaks, etc.) to Terminals 13 and 14.
(+)
13
Auxiliary Power provides a filtered 12 VDC nominal output which is used for powering auxiliary
AUX POWER
devices. NOTE: To calculate the available standby time refer to the Standby-Battery Calculation
(-)
Worksheet at the back of this manual.
14
L
NAPCO Security Systems
NOTE: Refer to the EZM Installation Instructions for
specific wiring information.
1. KEYPADS: GEM-RP1CAe2, GEM-RP2ASe2, GEM-RP3DGTL, GEM-
K1CA, GEM-K2AS and GEM-K3DGTL.
2. X-10 INTERFACE: GEM-X10
3. WIRED ZONE EXPANDER: GEM-EZM4 & GEM-EZM8
4. WIRELESS RECEIVERS: GEM-RECV8, GEM-RECV16 & GEM-RECV96
5. RELAY MODULE: RM3008
6. VOICE INTERFACE: GEM-EVA 1
7. TELEPHONE INTERFACE: WIZARD IIe
GEMINI
SYSTEM ARMED
01/01/97
A 1 2
B 4 5 6
C 7 8 9 0
C OM PU TERIZED SEC U RITY SYSTEM
GEM-RP1CAe2
(2 LINE LCD KEYPAD)
(EZM/PGM Options 1 or 2)
WHITE
PANIC
WHITE
Select either option with GEM-RP1CAe2/GEM-K1CA keypads. Option 2 for use with GEM-RP2ASe2/
GEM-K2AS keypads only.
Option 1. Activates the PGM lug on the corresponding EZM module(s). Lug goes active (low) when
RB1000 Relay
BLK
any selected Area is armed.
(recommended)
13
RED
Option 2. The Access Code will activate the keypad's PGM brown wire while armed or disarmed if
the User Code is programmed for "Access Control on PGM Lug". The Access Code is pro-
(–)
External grammed as any other User Code but without arm/disarm capability. Note: Options not investi-
Power
(+)
gated by UL.
Door
Supply
RED
Strike
Connect the control panel EARTH GROUND screw through a No. 16 AWG.
or larger wire to a metal cold-water pipe. Do not use a gas pipe, plastic pipe
or AC ground connections. Also, connect the circuit board to the metal enclo-
sure. Connect a wire with a ground lug crimped or soldered onto one end of
the EARTH GROUND screw to the cabinet. NOTE: Grounding connections
should avoid bends in the grounding wire whenever possible.
AVAILABLE DEVICES
12:00AM
N EX T/Y ES
3 E
D
P RIOR /NO
F
AR E A
G
R
BROWN
Keypad Brown Wire: EZM/PGM Output Options
X
GEM-P9600 Installation Instructions
Page 15
Door
Strike
External
(N/O) (+)
RB1000 Relay
BLK
Power
(recommended)
(–)
Supply
(COM)
13
RED
!