Advertisement
PROBLEMS
1.
Oven Burner/Broil Burner will
not turn on. "Selector" switch set
on BAKE/BROIL. Thermostat set
at 350°/Broil. Door latch in cook
position.
NOTE: The flat type ignitor
used in these models has an
operating current range of from
3.2 amps A.C. to 3.6 amps A.C.
The gas valve is calibrated to
open at slightly over 3.2 amps,
since the ignitor will be hot
enough to ignite any gas flowing
from the burner. The current
can be checked using a
clamp-on ammeter or an in-line
ammeter. If the current does not
reach 3.2 amps, replace the
ignitor.
2.
Gas valve opens but
Oven/Broiler burner does not
ignite.
PROBLEMS
1.
No Self-Clean
POSSIBLE CAUSE
A.
No 120 VAC to range.
B.
Inoperative ignitor.
C.
Inoperative gas valve.
D.
Inoperative selector switch.
E.
Inoperative thermostat.
F.
Faulty wiring.
A.
BAKE/BROIL igniotr positioned
too far from burner.
B.
Incorrect adjustement/or
incorrect burner orifice on broil
burner. (LP GAS).
POSSIBLE CAUSE
A.
Controls not set properly.
B.
Faulty latch switch.
C.
Oven or broiler burner does not
turn on.
CORRECTION
A.
Check electric
B.
Check ignitor
page --. Rep
C.
Check gas va
on page --. R
D.
Check selecto
instructions on
switch.
E.
Check thermo
on page --. R
Check wiring
diagram and
connections a
A.
Reposition BA
the burner.
B.
Adjust univers
Install correct
CORRECTIO
A.
Turn selector
door latch to
oven heat co
Oven indicato
not refer to n
models do no
B.
Check for 12
with the door
voltage is pre
is OK; if not,
C.
Check unit in
insure both f
both function
are OK proce
check apprip
procedure in
Advertisement
