Advertisement
PROBLEMS
F. "DOOR" appears in
display when E.R.C. is
programmed for bake or
broil.
G. "LOCK" appears in
display when oven is
not programmed and at
room temperature.
H. Oven temperature
display does not
increment to set
temperature during
preheat. Oven element
operates but not cycle.
POSSIBLE CAUSE
1.
Door latch is set to far right
or clean positon.
2.
Shorted door latch switch
wire or shorted latch switch.
3.
Defective E.R.C.
1.
Oven temperature sensor
resistance too high.
2.
Defective E.R.C.
1.
Sensor resistance too low or
not changing with
temperature rise.
2.
Defective E.R.C.
CORRECTION
1. Door latch should be set to fa
bake or broil functions.
Check for shorted latch switc
ground. If continuity is indica
switch contacts to determine
switch). If no continuity is in
If Steps 1 and 2 above chec
1.
Disconnect temperature sens
sensor resistance. At room t
should be 1091 ± 5.5 ohms.
indicated, replace sensor. If
check wire harness resistanc
connections. Each harness
(0) ohms. If resistance is ind
If wire harness and sensor c
2.
2.
If wire harness and sensor c
replace the E.R.C.
1. Defective oven temperature
plug and attach ohmmeter le
Resistance at room temperat
approximately 1091 ohms. A
using a hair dryer or heat gun
should increase with sensor t
resistance does not increase
resistance increases proceed
If sensor checks good in Ste
Advertisement
