Advertisement
PROBLEMS
1.
Burners will not ignite "SPARK"
at top burner ignitors.
2.
Burner will not ignite. No
"SPARK" at top burner ignitors.
Burner knob pushed down and
held in "LIGHT" position.
POSSIBLE CAUSE
A.
Burner venturi, burner cap or
burner ignition ports clogged.
B.
Air Shutters out of adjustment.
C.
Burner flame not correctly
adjusted (LP GAS).
D.
Poor ground on ignitor
grounding bracket or gap
between ignitor and bracket
dimple is too large.
A.
No 120 VAC to range.
B.
Micor Switch contacts not
closing.
C.
Faulty wiring.
D.
Inoperative spark module.
E.
Ignitor ceramic dirty, spark gap
out of adjustment
CORRECTIO
A.
Clean burner
B.
Adjust air sh
in installation
Adjust burner
conversion in
instructions.
C.
Tighten brack
(- 1/32", + 0")
A.
Check electri
B.
Check wiring
and be sure
are correct a
C.
Check wiring
and be sure
are correct a
D.
Check modu
on page --.
E.
Clean cerami
spark gap
Advertisement
