Figure 29-7 Menu 11.6 For Vc-Based Multiplexing; Figure 29-8 Menu 11.6 For Llc-Based Multiplexing Or Ppp Encapsulation - ZyXEL Communications Prestige 653HWI series User Manual

Prestige 653HWI Series User's Guide
29.5.1 VC-based Multiplexing (non-PPP Encapsulation)
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, for
example, VC1 will carry IP. Separate VPI and VCI numbers must be specified for each protocol.
VC Options for IP:
VPI #= 8
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
29.5.2 LLC-based Multiplexing or PPP Encapsulation
For LLC-based multiplexing or PPP encapsulation, one VC carries multiple protocols with protocol
identifying information being contained in each packet header.
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (LLC-Multiplexing or PPP-Encapsulation)
ENTER here to CONFIRM or ESC to CANCEL:
.

Figure 29-8 Menu 11.6 for LLC-based Multiplexing or PPP Encapsulation

In this case, only one set of VPI and VCI numbers need be specified for all protocols. The valid range for
the VPI is 0 to 255 and for the VCI is 32 to 65535 (1 to 31 is reserved for local management of ATM
traffic).
29-10
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
Press ENTER to Confirm or ESC to Cancel:

Figure 29-7 Menu 11.6 for VC-based Multiplexing

VPI #= 8
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
VC Options for Bridge:
VPI #= 1
VCI #= 36
ATM QoS Type= N/A
Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBR)= N/A
Separate VPI and
VCI numbers must
be specified.
Only one set of VPI
and VCI numbers
needs to be
specified.
Remote Node Configuration