Table of Contents
Advertisement
SETTING UP
Loading the recording paper
1.
2.
3.
4.
Unwrap the roll of recording paper.
Pull the operation panel knob on the right side of
the machine forward, and open the operation
panel. The buzzer will sound briefly.
Place the roll of paper in the paper compartment
so that the hubs on each end of the paper com-
partment fit into the ends of the roll. The hub on the
left end of the compartment is mounted on a spring
to allow for inseftion.
Important: The roll should be placed so
that the leading edge of the paper feeds
from the top of the roll.
Pass the leading edge of the paper under the cutter
guide and pull it out through the received document
exit. Remove any slack.
s. Close the operation panel by gently pushing down
on the center. A short length of the recording paper
will be fed out and cut off.
Ifthis does not happen, repeat the loading
procedure.
INSTALLATION
2-5
Advertisement
Table of Contents
