Repositioning The Touch Screen - Roland Atelier AT-90SL Owner's Manual

Chapter 10 Various Other Settings
2.
Touch <Tx MIDI Ch. Upper>, <Tx MIDI Ch.
Lower>, <Tx MIDI Ch. Pedal>, <Tx MIDI Ch.
Solo>, <Tx MIDI Ch. Drums> (Tx MIDI Ch.
Drums/SFX), <Tx MIDI Ch. M.Perc> (Tx MIDI
Ch. Manual Percussion) or <Tx MIDI Ch. Cntrl>
(Tx MIDI Ch. Control).
The Control part transmits Expression pedal data and
PC numbers.
3.
Touch < >< > to change the setting.
Channel 1–16
4.
Touch <Exit>.
NOTE
MIDI messages for the Solo part will be transmitted only
when the Solo [To Lower] button is ON.
198
Max Max Max Max
Min Min Min Min

■ Repositioning the Touch Screen

If you've been using the Touch Screen for some time, the
pointer may be shifted, making the AT-90SL react
incorrectly. You should correct this displacement when
necessary by performing calibration (repositioning).
1.
Touch <System> on the Main screen.
The System screen appears.
2.
In the System screen, touch <Utility>.
The Utility screen appears.
3.
Touch <Touch Screen>.
A display will ask for confirmation.
To cancel the operation, touch <Cancel>.
4.
Touch <OK> on the screen.
5.
Touch the points indicated on the touch screen.
NOTE
Do this carefully, because touching a location that's different
from the one indicated for the pointer may make the
displacement even worse. Be sure to touch the pointer
accurately. If the following display appears, perform the
touch panel position adjustment once again.
Harmony Intelligence