Korg TRITON proX Manual page 236

Action: Execute the reading operation once again. If the
same error occurs, it is possible that the data on
the disk has been damaged.
Error in writing to medium
Meaning: An error occurred while writing data to a
medium. (Verify error)
Action: It is possible that the floppy disk has been physi-
cally damaged. Try another disk. Avoid using the
floppy disk that produced the error.
F
File already exists
Meaning: When executing a Create Directory or File
Rename operation, a directory or file of the same
name already exists on the disk.
Meaning: When executing the Disk mode Utility "Copy"
command without using wild cards, the copy des-
tination contained a file of the same name as the
copy source.
Action: Either delete the existing directory or file, or spec-
ify a different filename.
File is read-only protected
Meaning: You attempted to write to a file or to delete a file
that had a read-only attribute.
Meaning: You attempted to save a file to a floppy disk that
contained a read-only file of the same name.
Action: Save the file with a different name.
File unavailable
Meaning: You attempted to load or open a file whose format
was incorrect.
File/path not found
Meaning: When loading a sample file in Disk mode, the file
name specified in the dialog box for selecting a
directory hierarchy or other media did not exist in
the specified location.
Meaning: When executing the Disk mode Utility command
"Delete," the specified file did not exist.
Meaning: When executing the Disk mode Utility command
"Copy" and you used a wild card to specify the
copy file name, the specified file was not found.
Alternatively, the length of the copy source path
name exceeded 76 characters.
Meaning: In Disk mode or Song Play mode when you used
the Open button to open a directory, the path
length including the selected directory name
exceeded 76 characters.
Action: Check the file or directory.
Format not supported
Meaning: For an AIFF file etc., you attempted to load a file
format that the TRITON series does not support.
Action: If possible, use a computer etc. to convert the data
into a format supported by the TRITON, and load
it.
230
I
Illegal file description
Meaning: The filename that you specified when saving a file
or creating a directory contained invalid charac-
ters.
Action: Change the filename you are specifying. Filena-
mes not permitted by MS-DOS cannot be used as
a filename.
Illegal SMF data
Meaning: You attempted to load a file that was not a Stan-
dard MIDI File.
Illegal SMF division
Meaning: You attempted to load a Standard MIDI File that
was timecode-based.
Illegal SMF format
Meaning: You attempted to load a Standard MIDI File of a
format other than 0 or 1.
M
Master Track can't be recorded alone
Meaning: When realtime-recording a single track, you
attempted to begin recording with the master
track as the current track.
Action: Begin recording with a track 1–16.
Measure size over limit
Meaning: When loading a Standard MIDI File, the number
of events in a measure exceeded the maximum
(approximately 10,000 events).
Meaning: The attempted edit operation would cause the
maximum number of events in a measure
(approximately 10,000) to be exceeded.
Action: Use event editing etc. to delete unwanted data.
Measure number over limit
Meaning: The attempted edit operation would cause the
track length to exceed 999 measures.
Action: Delete unnecessary measures.
Medium changed
Meaning: When executing the Disk mode Utility command
"Copy," the media was exchanged or ejected, and
it was not possible to copy between separate
media on the same drive.
Medium write protected
Meaning: The floppy disk or other media to which you
attempted to save is write-protected.
Action: Turn off write protect on the floppy disk or other
media, and execute the command once again.
Memory full
Meaning: In Sequencer mode when editing a song, track or
pattern, the total data of all songs has used up all
of the sequence data memory, and further editing
is not possible.
Action: Delete other song data etc. to increase the amount
of free memory.