Korg TRITON proX Manual page 139

At the same time, programs within the .PCG file that use
multisamples from the .KSC file will automatically have
the multisample settings for their oscillators rewritten so
that each program uses the correct multisample. Drum
kits in the .PCG file that use samples from the .KSC file
will automatically have the sample settings for the drum
kit rewritten so that the drum kit uses the correct sam-
ples.
Clear: All multisamples and samples currently in mem-
ory will be erased, and the multisamples and samples
will be loaded in the same configuration in which they
were saved. (See diagram below.)
If memory already contains multisamples or samples
that you wish to keep, and you wish to load additional
multisamples or samples from disk, select Append.
If the power has just been turned on, or you want to
reproduce the state that was saved, select Clear.
.KSC file to be loaded TRITON internal
memory after loading
MS000 MS000
MS001
MS002
MS003 MS003
Append
MS004
MS005 MS005
MS006
MS007
MS000 MS000
MS001 MS001
MS003 MS003
Clear
MS005
MS005
3 To load the data, press the OK button. To cancel without
loading, press the Cancel button.
2) Load Programs:
All program data from a .PCG file will be loaded.
1 To load the data, press the OK button. To cancel without
loading, press the Cancel button.
3) Load Program Bank [A–F]:
All program data of the selected bank will be loaded into the
bank you specify.
1 In "To," select the loading destination bank.
Bank F program data can be loaded only into bank F. If
you select bank A–E, it will not be possible to select
bank F in "To."
2 To load the data, press the OK button. To cancel without
loading, press the Cancel button.
4) Load a Program:
Data for the selected program will be loaded into the pro-
gram number you specify.
1 If you wish to load a program other than the one already
selected, use "Program" to select the program that you
wish to load.
2 In "To Program," select the bank and program into which
the data will be loaded. When you press the popup but-
ton, the "Bank/Program Select" window ( Program P0:
0–1a) will appear.
TRITON internal
before loading
3 To load the data, press the OK button. To cancel without
MS000
loading, press the Cancel button.
MS002
MS003
5) Load Combinations:
All combinations in the .PCG file will be loaded.
MS000
MS002
MS003
1 To load the data, press the OK button. To cancel without
loading, press the Cancel button.
6) Load Combination Bank [A–D]:
All combinations in the selected bank will be loaded into the
bank you specify.
selected icon
1 In "To," specify the loading destination bank.
2 To load the data, press the OK button. To cancel without
loading, press the Cancel button.
7) Load a Combination:
The combination you select will be loaded into the loading
selected icon
destination combination number you specify.
1 If you wish to load a combination other than the one
already selected, use "Combination" to select the combi-
nation that you wish to load.
2 In "To Combination," select the bank and combination
into which the data will be loaded. When you press the
popup button, the "Bank/Combination Select" window
( Combination P0: 0–1a) will appear.
3 To load the data, press the OK button. To cancel without
loading, press the Cancel button.
Data for one bank F program can be loaded only into
bank F. Banks A–E will not be displayed.
selected icon
selected icon
selected icon
selected icon
133