JUKI DDL-8700 Instruction Manual page 33

@9 Retry function (Function setting No. 73)
When the retry function is used, if the sewing material is thick and not piereced with needle, this function
makes the needle pierce in the material with ease.
7 3
#0 One-shot function up to material end (Function setting No. 76)
This function can perform the one-shot automatic stitching up to the end of material in combination with the
material end sensor when the operation panel is not connected.
7 6
#1 Function of pedal curve selection (Function setting No. 87)
This function can perform the selection of the curve of number of rotation of the sewing machine against the
depressing amount of the pedal.
Change to this function when you feel that inching operation is hard or that pedal response is slow.
8 7
#2 Function added to the needle up / down compensating switch (Function setting No. 93)
One stitch operation can be performed only when the needle up / down compensating switch is pressed at
the time of upper stop immediately after turning ON the power switch or upper stop immediately after thread
trimming.
9 3
#3 Setting of max. number of rotation of the sewing machine head (Function setting No. 96)
This function can set the max. number of rotation of the sewing machine head you desire to use.
Upper limit of the set value varies in accordance with the sewing machine head to be connected.
9 6
4 0 0
0 : Normal
1
1 : Retry function is provided.
0 : Without one-shot function
0
1 : With one-shot function
0 : Number of rotation of the sewing machine
0
in terms of the depressing amount of the
pedal increases linearly.
1 : Reaction to intermediate speed in terms
of the depressing amount of the pedal is
delayed.
2 : Reaction to intermediate speed in terms
of the depressing amount of the pedal is
advanced.
0 : Normal (Only needle up / down compensating stitching operation)
0
1 : One stitch compensating stitching operation (upper stop ıî upper stop) is
performed only when aforementioned changeover is made.
150 to Max. [rpm] <50 / rpm>
0
31
2
0
Pedal stroke (mm)
1