JUKI AMB-289 Instruction Manual page 94

Pictograph
Error code
E497
E498
E499
E702
E703
E704
E730
E731
E733
E801
E802
Description of error
Tongue type error
When AMB-289 type tongue and AMB-189
type one are mixedly used in the cycle
data.
Button holding height over at the time
of sewing
Button holding height is too high and
sewing cannot be performed at the time of
button sewing.
Y feed motor move limit value over
When input data of shank/marble sewing
exceed the maximum of Y feed move
amount (max. operating amount : 15 mm).
Abnormality of display data
When there is no display data of panel.
Panel is connected to the machine other
than supposed. (Machine type error)
When machine type code of system is
improper in case of initial communication.
Nonagreement of system version
When version of system software is
improper in case of initial communication.
Main shaft motor encoder defectiveness
or phase-out
When encoder of sewing machine motor
is abnormal.
Main motor hole sensor defectiveness
or position sensor defectiveness
When hole sensor or position sensor of
sewing machine is defective.
Reverse rotation of main shaft motor
When sewing machine motor rotates in
reversedirection.
Phase-lack of power
When phase-lack of input power occurs.
Power instantaneous cut detection
When input power is instantaneously OFF.
@– 90
How to recover Place of recovery
Data input screen
Possible to
recover by
reset.
Data input screen
Possible to
recover by
reset.
Possible to
Data input screen
recover by
reset.
Turn OFF the
power.
Rewriting of
program
Possible to rewrite
C o m m u n i c a t i o n
p r o g r a m a f t e r
screen
pressing down
communication
switch.
Possible to rewrite
C o m m u n i c a t i o n
p r o g r a m a f t e r
screen
pressing down
communication
switch.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.
Turn OFF the
power.