JUKI AMB-289 Instruction Manual page 44

No.
Thinning level of the stay button
This item decreases the number of cross-over stitches of
the lower side button at the time of stay button sewing.
: Without thinning
: Thinning level 2
Lateral compensation of needle entry of lower button at the time of
sewing counter button (front : 4 holes, rear : 2 holes)
Perform compensation to such an extent
that needle does not come in contact with
buttonhole within the range of lower buttonhole.
Number of stitches of tie stitch at the end of sewing
flat button directly to cloth.
This item sets the number of stitches of tie stitch
at the end of sewing flat button directly to cloth.
Number of stitches of tie stitch at the end of counter sewing
This item sets the number of stitches of tie
stitch at the end of counter sewing.
Button sewing height
(only neck wrapping of sewing flat/
wrapped-around button with blindstitch)
This item sets the button holding height
(finished height) in the neck wrapping process.
Button height (shank/marble)
This item sets the button holding height
(finished height) in the neck wrapping process.
Button height (counter button)
This item sets the button holding height
(finished height) in the button sewing process.
Number of stitches at the start of sewing
of neck wrapping
This item sets the number of stitches at the
start of sewing of neck wrapping.
Number of stitches of tie stitch at the end
of sewing of neck wrapping
This item sets the number of stitches of tie stitch at
the end of sewing in the neck wrapping process.
Compensation of the button holding height at the time of
sewing flat/wrapped-around button with blindstitch
This item sets when compensating the button holding
height in the button sewing process and desiring to give
slackness between button and neck wrapping section.
Thread release compensation
This item is the compensation value of the button
holding height in the button sewing process. Sewing is
performed in the neck wrapping process by gradually
returning the compensation value to the former one.
This item is set when desiring to tightly wrap up to the
root of the button.
Item
: Thinning level 1
: Thinning level 3
@– 40
Setting range Edit unit Initial display Remarks
– – – – – –
0 to 0.30 0.05mm
2 to 3 1 stitch
1 to 3 1 stitch
0.5 to 0.1mm
15.0
0 to 15.0 0.1mm
0 to 20.0 0.1mm
1 to 3 1 stitch
2 to 3 1 stitch
–5.0 to 5.0 0.1mm
–5.0 to 5.0 0.1mm
Without
thinning
0.30
2
2
2.5
3.4
4.5
2
2
–0.5
0.5