JUKI AMB-289 Instruction Manual page 48

5
6
*1 Cycle data can be copied by the same method.
*2 When deletion is performed in case the remaining pattern No. which has been registered
is one, pattern deletion error (Error code 402) is displayed.
*3 When trying to perform copying to the pattern No. which has been already registered,
copy disapproval error (Error code 401) is displayed.
8
7
@– 44
4) Input the pattern No. of copy destination.
Input the pattern No. of copy destination
with ten keys 5 . It is possible to retrieve
the pattern No. which is not used with –・+
buttons
5) Start copying.
Press ENTER button
starts.
P a t t e r n N o . w h i c h h a s b e e n c o p i e d i n
the selected state returns to the pattern
copy (copy source selection) screen after
approximately two seconds.
( 6 ・ 7 ).
8 and copying